When removing lath and plaster ceiling, it’s good to make a start somewhere. It holds the plaster together so big unexpected pieces are unlikely to fall uncontrollably. Lath and plaster ceiling removal can be a bit more work because of that or the wire mesh can help a little. The galvanized mesh is most probably used and in older houses, it can be some sort of old chicken wire mesh. The best way to remove lath and plaster ceiling is not working directly under it Lath and plaster ceilingĬeilings are done in the same fashion as the walls. If there is mesh supporting it and how it all is adhering to the lath. I wouldn’t say that it’s necessary harder than fixing holes in drywall, but it all depends on how well the wall is set in place. Lath and plaster repair is also something that needs some work to be done. You would place the money straight to this one for being the cheaper option. A board with fire-resistant attributes that can be screwed to the wall with a single man and all that needs to be done is a joint compound and some joint tape. So to cover it all and finish you need multiple layers of plaster so it will naturally cost the material and the labor. Plaster walls need the lath or special board behind them and there is also galvanized mesh used in modern plastering to help to fight against cracks as the wood behind lives its own life. When it comes to wooden lath and plaster vs drywall, the last one was originally created to offer a cheaper option for plaster walls. There is also guide for removing plaster from brick, concrete and dryw all. If you’re interested in wooden lath and plaster removal, there is a guide on the link. There are also plywood and different kinds of wooden boards that you see now and then. Other than that, concrete walls can be there as supporting walls and the same goes for brick walls. Its form has gone through updates with fire safety and such, but it’s pretty much the same material overall. There aren’t that many old drywall types, it started to become common after WWII. It’s a method still used today, only a wood lathe is not used sometimes as there are special boards that can be used instead. Naturally, plaster and lathe is a quite old way to do walls. What ever the case is, I’ll try to open up this topic up so you will get more knowledge about the subject. Thanks for that Apart from a box room and a wee bathroom adding some inches to the exterior walls shouldn't be a problem in most rooms, though as you say it will be a lot of work: there will be a fair bit of stuff like cornices, architraves & fire surrounds to replace/move.Have you gotten yourself an old house, but don’t know much about plaster and lathe? Or maybe you want to work on your house that has plaster walls with a wooden lathe behind them. If rooms are big enough you don,t even need to rip out old plaster +lathes-just build a modern house inside it inside it ?Īpply vapour barrier to the frames before you lift them up into place and you got full damp proofing at same time and a gap for the old walls to breath into the roof spaceĪ house that old will be built with a cold roof and lots of drafts in the loft area -so you kill all problems at same timeĪlso will be a job you can do while still living in it ,a bit at a time if you wishįilling the gap with anything will stop the air flow to the roof you must have with this type of old house -you will make more damp problems Maybe a bigger job then you wanted but is the right way to go long term and also a chance to replace electrics etc at same time and have house with modern insulation stds Maybe time to think about getting rid of the lathe and plaster and build stud walls -providing rooms are not very small
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |